Do You Realize Installation Debugging of Raymond Mill
Posted Dec 25, 2013 | Visits: 633 | Stock No: #24969Tweet
Raymond mill is widely used for grinding non-flammable and non-explosive materials whose Moh’s hardness is below 9.3 and humidity less than 6% such as barite, calcite, potassium feldspar, talc, marble, limestone, dolomite, fluorite and lime, activated clay, activated carbon, bentonite, kaolin, cement, phosphate rock, gypsum, glass and thermal insulation materials in mine, metallurgy, chemistry and building industry. So it is an important mining machine in the grinding production line. And we should also know something about the installation debugging of the Raymond mill.
Installation debuggings of the Raymond mill are in the following:1, Raymond mill run the scene is not installed, should be properly kept, exposed surface shall be coated with anti-rust oil, and to avoid or, in case of rust water body to establish a system maintenance.2, plant and shall be installed according to Raymond mill figure size should have enough height and installation location, Raymond mill based high cement should be used and must be buried have reinforced to the foundation, and threading pipe or cable ducts.3, should be equipped with 2 ~ 3 tons lifting tool, for Raymond mill installation and maintenance.4, Raymond mill from the factory to use for more than 6 months, the host central axis system, transmission device, roller device, analysis the oil pool, etc. Shall be clean, clean the check for the parts after the deal with add enough lubricating oil.
In addition, in order to ensure that the Raymond mill powder machine is normal, you should be developed equipment "equipment maintenance security operating system" in order to guarantee the Raymond mill long-term safe operation, at the same time to have the necessary maintenance tools and grease and the corresponding accessories. Raymond mill roller device used for more than 500 hours to replace the roller, the roller set inside of the rolling bearing must be clean, the damaged parts should be replaced in a timely manner, refueling tools available manual pumps and grease gun. Raymond mill, in use process should be fixed personnel responsible for the supervision, the operator must have a certain technical level. Raymond mill before installation must make the necessary technical training to operators, to understand the principle of Raymond mill performance, familiar with the operation procedures.